Clobber Hercules Drain And Waste System Cleaner

Description

Clobber Hercules Drain And Waste System Cleaner

A heavy-duty, sulfuric acid drain solvent formulated specifically for  emergency use by professionals. Heavier than water, Clobber flows quickly to the blockage allowing special wetting agents to rapidly clear drain, sewer or waste line.  It disintegrates paper, rags, sanitary products, grease, sludge, soap, fat, wood, hair, all types of food and organic matter. 

Clobber is formulated with 93% virgin sulfuric acid concentrate and additives that inhibit corrosive action on ferrous and non-ferrous metals. In an independent laboratory test, Clobber was rated superior to similar type products in preventing corrosion. Because Clobber causes a significant rise in temperature when added to water, it can be used to thaw frozen lines. Will not harm septic tanks, cesspools, drainage fields and leaching systems when used according to directions.

Technical Characteristics

• Fastest method for clearing emergency waste line stoppages
• Rapidly disintegrates paper, rags, food and all organic matter
• Formulated to inhibit corrosive action on ferrous and non-ferrous metals
• Will not harm septic tanks, cesspools, drainage fields and leaching systems when used according to directions
• May be used on cast iron, steel, copper, brass, lead and plastic pipell
• Can be used to thaw frozen lines
• SAF-T-POR spout included with each 1/2 gallon jug to permit safe, easy pin-point application without hazardous spilling
• Certified by NSF/USDA
• Boiling Point: 168^οC

Packaging:  Clobber comes in a molded-handle plastic jug with child-proof caps preventing accidental openings. It is sealed in a plastic bag with warning tags. Jugs are packed in D.O.T. approved cartons. A SAF-T-POR spout is included with each 1/2 gallon jug of Clobber to permit safe, easy pin-point application without hazardous spilling.   Available in 1/4 gal & 1/2 gal bottles.

DIRECTIONS FOR USE

WEAR GOGGLES OR FACE SHIELD AND RUBBER GLOVES. HOLD PRODUCT AT ARM’S LENGTH.

1. Remove standing water from drain.
2. Determine Clobber dosage and “ALLOW TO STAND” time for type of facility from table below.
3. Put on acid-resistant gloves and goggles or face shield. Stand clear of drain opening.
4. To open container, place on a flat surface. Hold bottle with one hand and unscrew cap taking care not to squeeze or tilt bottle.
5.  Slowly pour a small amount of Clobber (less than 1/4 pint) DIRECTLY INTO DRAIN OPENING. Keep face and hands away from opening.
6.  If no “bubbling” or backup occurs, add rest of dosage slowly and carefully. DO NOT splash or spill Clobber outside of drain opening. Immediately recap container tightly after use.
7.  After pouring Clobber into drain, immediately place inverted dishpan, bucket or other deep container over drain opening to protect against possible eruption of drain contents and acid.
8. Allow to stand for recommended time before flushing.
9.  Flush by adding one-quart cold water. Wait 5 minutes. If line is clear, flush thoroughly with cold water.
10. Recommended dosages will open most lines and drains. If stoppage persists, repeat dosage, “ALLOW TO STAND” time and flush procedures.

FACILITY DOSAGE ALLOW TO STAND

• – Small drains, waste lines & traps 1/2 pint 5 to 15 minutes
• – 3” or 4” lines 1 quart 15 to 30 minutes
• – 6” or 8” lines 1/2 gallon 15 to 30 minutes
• – Urinals 1 pint 15 minutes
• – Toilet bowls DO NOT use Clobber.

WARNINGS 

• FOR PROFESSIONAL USE ONLY
• DO NOT use Clobber where other drain chemicals, hot water, or bleach are present.
• Keep out of reach of children.
• DO NOT allow Clobber in contact with non-acid resistant enamel, stainless steel, chrome, aluminum, galvanized and certain plastics.
• DO NOT use plunger when Clobber is in drain.
• DO NOT apply Clobber through garbage disposals.
• Avoid backup from drain opening by closing all connecting drains until this product is flushed from system.
• Stand clear of drain openings immediately during and after use.
• Wear heavy acid resistant gloves and goggles or face shield when handling.
• Keep container closed when not in use. Avoid spills – this product will attack all organic material.
• Use original container only – DO NOT transfer.
• Store in a cool, dry place away from oxidizing materials.
• Provide sufficient ventilation to prevent buildup and inhalation of vapors or mist.
• DO NOT add water or any other chemical to contents because of violent reaction.
• Wash contaminated equipment, shoes, and clothing thoroughly after handling.
• DO NOT use Clobber to remove stoppages due to sand, stone, cement or plaster. (Use Hercules Sizzle.)
• Clobber is a powerful acid – packaged for safe handling and application. It must always be handled with care. Label directions and precautions must be strictly observed.

CAUTIONS – WARNINGS: 

Η290: May be corrosive to metals      H314: Causes severe skin burns and eye damage..  Ρ102: Keep out of reach of children   Ρ280: Wear protective gloves/protective clothing/eye protection/face protection. Ρ301+Ρ330+Ρ331: IF SWALLOWED Rinse mouth.  Do NOT induce vomiting.  Ρ303+Ρ361+Ρ353: IF ON SKIN (or hair):Take off immediately all contaminated clothing. Rinse skin with water [or shower].  Ρ305+P351+Ρ338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Ρ310: Immediately call a POISON CENTER or a doctor. Ρ405: Store locked up.  Ρ501: Dispose of contents/container according to local / regional / national / international regulations.

Technical Specification Sheet: Download here

MSDS: Download here

Certifications\Approvals: Download here